Home › Engine / Hybrid System › 2KD-FTV FUEL › FUEL FILTER
RM1840EF _51 Engine / Hybrid System _009578 2KD-FTV FUEL _0052218 FUEL FILTER G

2KD-FTV FUEL  FUEL FILTER  INSPECTION  


PROCEDURE

Hide 1.INSPECT FUEL FILTER ASSEMBLY

a.
A301779

Inspect the level warning switch.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 Float at upper end position Below 1 Ω
Float at lower end position 10 kΩ or higher


If the result is not as specified, replace the fuel filter assembly.



b.

Inspect the clogging switch.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) Below 1 Ω


If the result is not as specified, replace the fuel filter assembly.