1.INSTALL INJECTOR DRIVER BRACKET
w/ DPF:
Install the injector driver bracket with the 4 screws.
w/o DPF:
Install the injector driver bracket with the 3 screws.
2.INSTALL INJECTOR DRIVER ASSEMBLY
w/ DPF:
Install the injector driver assembly with the 2 bolts.
Connect the 4 connectors.
w/o DPF:
Install the injector driver assembly with the 2 bolts.
Connect the 3 connectors.
3.INSTALL GLOW PLUG CONTROLLER (w/ DPF)
4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).