Home › Engine / Hybrid System › 2KD-FTV FUEL › INJECTOR DRIVER › 2011.10–2012.01
RM1840EF _51 Engine / Hybrid System _009578 2KD-FTV FUEL _0052220 INJECTOR DRIVER A

2KD-FTV FUEL  INJECTOR DRIVER  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.REMOVE INJECTOR DRIVER ASSEMBLY

a.
A231858

Disconnect the 3 connectors.


b.

Remove the 2 bolts and injector driver assembly.


Hide 4.REMOVE INJECTOR DRIVER BRACKET

a.
A224468

Remove the 3 screws and injector driver bracket.