Home › Engine / Hybrid System › 2KD-FTV FUEL › COMMON RAIL(w/ DPF) › 2012.04–2012.10
RM1840EF _51 Engine / Hybrid System _009578 2KD-FTV FUEL _0052226 COMMON RAIL(w/ DPF) A

2KD-FTV FUEL  COMMON RAIL(w/ DPF)  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the injectors (including shuffling the injectors between the cylinders), common rail or cylinder head, it is necessary to replace the injection pipes with new ones.

·

When replacing the fuel supply pump, common rail, cylinder block, cylinder head, cylinder head gasket or timing gear case, it is necessary to replace the fuel inlet pipe with a new one.

·

When replacing the common rail, do not remove the foreign object mixing prevention caps of the common rail until just before the fuel inlet pipe and injection pipe are connected to the common rail.

·

After removing the injection pipes and fuel inlet pipe, clean them with a brush and compressed air.



PROCEDURE

Hide 1.INSTALL COMMON RAIL ASSEMBLY

a.

Install the common rail with the 2 bolts.

Torque:
38 N*m (387 kgf*cm, 28 ft.*lbf)


b.

Connect the pressure discharge valve connector.


Hide 3.INSTALL NO. 2 NOZZLE LEAKAGE PIPE ASSEMBLY

Hide 8.INSTALL ELECTRIC EGR CONTROL VALVE ASSEMBLY WITH NO. 2 EGR VALVE AND EGR COOLER

Hide 9.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).