Home › Engine / Hybrid System › 2KD-FTV FUEL › COMMON RAIL(w/ DPF) › from 2012.10
RM1840EF _51 Engine / Hybrid System _009578 2KD-FTV FUEL _0052226 COMMON RAIL(w/ DPF) A

2KD-FTV FUEL  COMMON RAIL(w/ DPF)  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the injectors (including shuffling the injectors between the cylinders), common rail or cylinder head, it is necessary to replace the injection pipes with new ones.

·

When replacing the fuel supply pump, common rail, cylinder block, cylinder head, cylinder head gasket or timing gear case, it is necessary to replace the fuel inlet pipe with a new one.

·

After removing the injection pipes and fuel inlet pipe, clean them with a brush and compressed air.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.REMOVE ELECTRIC EGR CONTROL VALVE ASSEMBLY WITH NO. 2 EGR VALVE AND EGR COOLER

Hide 4.REMOVE NO. 4 INJECTION PIPE SUB-ASSEMBLY

Hide 8.REMOVE NO. 2 NOZZLE LEAKAGE PIPE ASSEMBLY

Hide 10.REMOVE COMMON RAIL ASSEMBLY

a.

Disconnect the pressure discharge valve connector.


b.
A239630

Remove the 2 bolts and common rail.

NOTICE:

Do not remove the pressure discharge valve or fuel pressure sensor.