Home › Engine / Hybrid System › 1KD-FTV FUEL › FUEL SENDER GAUGE ASSEMBLY
RM1840EF _51 Engine / Hybrid System _009579 1KD-FTV FUEL _0052235 FUEL SENDER GAUGE ASSEMBLY G

1KD-FTV FUEL  FUEL SENDER GAUGE ASSEMBLY  INSPECTION  


PROCEDURE

Hide 1.INSPECT FUEL SENDER GAUGE ASSEMBLY

a.
A246464
1.104,1.781 0.323,1.781 true 0.906,4.115 0.333,4.115 true 0.177,4.031 0.313,4.177 0.135,0.146 10 false E 0.167,1.698 0.302,1.844 0.135,0.146 10 false F 0.052,0.042 0.24,0.198 0.188,0.156 10 false *a
*a Front view of wire harness connector
(to Fuel Sender Gauge Assembly)


Type A:

i.

Check that the float moves smoothly between F and E.


ii.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
2 - 3 Float position is F (upper) 3.0 to 5.0 Ω
Float position is E (lower) 109 to 111 Ω


If the result is not as specified, replace the fuel sender gauge assembly.



b.
A246392
1.427,2 0.479,2 true 1.281,4.198 0.51,4.198 true 1.375,0.844 1.5,0.99 0.125,0.146 10 false 3 1.76,0.844 1.885,0.99 0.125,0.146 10 false 2 2.135,0.844 2.26,0.99 0.125,0.146 10 false 1 0.365,4.115 0.5,4.26 0.135,0.146 10 false E 0.323,1.927 0.458,2.073 0.135,0.146 10 false F 0.052,0.042 0.24,0.198 0.188,0.156 10 false *a
*a Front view of wire harness connector
(to Fuel Sender Gauge Assembly)


Type B:

i.

Check that the float moves smoothly between F and E.


ii.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
2 - 3 Float position is F (upper) 3.0 to 5.0 Ω
Float position is E (lower) 109 to 111 Ω


If the result is not as specified, replace the fuel sender gauge assembly.