Home › Engine / Hybrid System › 1KD-FTV FUEL › FUEL SUPPLY PUMP(w/ Glow Plug Controller) › from 2012.04
RM1840EF _51 Engine / Hybrid System _009579 1KD-FTV FUEL _0052238 FUEL SUPPLY PUMP(w/ Glow Plug Controller) G

1KD-FTV FUEL  FUEL SUPPLY PUMP(w/ Glow Plug Controller)  INSPECTION  


PROCEDURE

Hide 1.INSPECT FUEL SUPPLY PUMP ASSEMBLY (for DPF)

a.
A191340
1.24,0.51 1.365,0.51 1.365,0.51 1.563,1.156 true 0.99,1.49 1.125,1.49 1.125,1.49 1.677,1.25 true 0.979,1.854 1.115,1.854 1.115,1.854 1.708,1.292 true 0.865,1.406 0.979,1.552 0.115,0.146 10 false 2 0.833,1.76 0.948,1.906 0.115,0.146 10 false 1 1.021,0.427 1.208,0.583 0.188,0.156 10 false *1
*1 Suction Control Valve


Inspect the suction control valve.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 1.9 to 2.3 Ω


If the result is not as specified, replace the fuel supply pump assembly.



b.
A231754
1.531,1.469 2.135,1.469 true 1.531,1.521 2.031,1.802 2.031,1.802 2.135,1.802 true 1.958,0.198 1.844,0.198 1.844,0.198 1.531,1.365 true 2.188,1.375 2.313,1.521 0.125,0.146 10 false 2 2.188,1.708 2.313,1.854 0.125,0.146 10 false 1 2.021,0.083 2.208,0.24 0.188,0.156 10 false *1
*1 Fuel Temperature Sensor


Inspect the fuel temperature sensor.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 2.32 to 2.59 kΩ


If the result is not as specified, replace the fuel supply pump assembly.



Hide 2.INSPECT FUEL SUPPLY PUMP ASSEMBLY (for i-ART)

a.

Inspect the suction control valve.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 1.9 to 2.3 Ω


If the result is not as specified, replace the fuel supply pump assembly.