Home › Engine / Hybrid System › 1KD-FTV FUEL › COMMON RAIL(w/ Glow Plug Controller) › from 2012.04
RM1840EF _51 Engine / Hybrid System _009579 1KD-FTV FUEL _0052239 COMMON RAIL(w/ Glow Plug Controller) G

1KD-FTV FUEL  COMMON RAIL(w/ Glow Plug Controller)  INSPECTION  


PROCEDURE

Hide 1.INSPECT COMMON RAIL ASSEMBLY (for DPF)

a.
A075928
0.104,0.104 0.292,0.26 0.188,0.156 10 false *a
*a Component without harness connected
(Common Rail)


Inspect the fuel pressure sensor.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
2 - 3 25°C (77°F) 16.4 kΩ or less
5 - 4 25°C (77°F) 16.4 kΩ or less
1 - 2 25°C (77°F) 3 kΩ or less
6 - 5 25°C (77°F) 3 kΩ or less


If the result is not as specified, replace the common rail assembly.



b.

Inspect the pressure discharge valve.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 0.96 to 1.16 Ω


If the result is not as specified, replace the common rail assembly.



Hide 2.INSPECT COMMON RAIL ASSEMBLY (for i-ART)

a.

Inspect the pressure discharge valve.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 0.96 to 1.16 Ω


If the result is not as specified, replace the common rail assembly.