Home › Engine / Hybrid System › 2TR-FE FUEL › FUEL INJECTOR › 2011.10–2012.01
RM1840EF _51 Engine / Hybrid System _009580 2TR-FE FUEL _0052242 FUEL INJECTOR A

2TR-FE FUEL  FUEL INJECTOR  REMOVAL  


PROCEDURE

Hide 1.DISCHARGE FUEL SYSTEM PRESSURE

Hide 2. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 4.REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY

Hide 5.DISCONNECT NO. 1 FUEL HOSE

a.
A252050

Disconnect the No. 1 fuel hose (See page Engine / Hybrid System>2TR-FE FUEL>FUEL SYSTEM>PRECAUTION).


Hide 6.DISCONNECT NO. 2 FUEL HOSE

a.
A252051

Disconnect the No. 2 fuel hose.


Hide 7.REMOVE FUEL PRESSURE PULSATION DAMPER ASSEMBLY

Hide 8.REMOVE FUEL DELIVERY PIPE WITH FUEL INJECTOR

a.
A252053

Disconnect the 4 wire harness clamps.


b.

Disconnect the 4 injector connectors.


c.

Disconnect the purge VSV connector.


d.
A252054

Remove the vacuum hose.


e.

Remove the 2 bolts and fuel delivery pipe together with the fuel injectors.

NOTICE:

Be careful not to drop the fuel injectors when removing the fuel delivery pipe.



f.
A223377

Remove the 2 No. 1 delivery pipe spacers.


g.

Remove the 4 injector vibration insulators.


h.

Using a screwdriver, remove the 4 spacers.

HINT:

Tape the screwdriver tip before use.



i.

Remove the O-ring from the spacer.


Hide 9.REMOVE FUEL INJECTOR ASSEMBLY

a.
A252052
1.635,1.26 1.646,1.333 false
V100135

Pull Out


Remove the 4 fuel injectors from the fuel delivery pipe.