Home › Engine / Hybrid System › 2TR-FE FUEL › FUEL PRESSURE PULSATION DAMPER › from 2012.10
RM1840EF _51 Engine / Hybrid System _009580 2TR-FE FUEL _0052244 FUEL PRESSURE PULSATION DAMPER A

2TR-FE FUEL  FUEL PRESSURE PULSATION DAMPER  REMOVAL  


PROCEDURE

Hide 1.DISCHARGE FUEL SYSTEM PRESSURE

Hide 2. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 5.REMOVE FUEL PRESSURE PULSATION DAMPER ASSEMBLY

A252059

a.

Remove the 2 bolts and fuel pressure pulsation damper.