1.INSPECT FUEL INJECTOR ASSEMBLY
Measure the resistance between the terminals.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - 2 | 20°C (68°F) | 11.6 to 12.4 Ω |
If the result is not as specified, replace the fuel injector assembly.
2.INSPECT INJECTION VOLUME AND LEAKAGE
Check the injection volume.
This test involves high-pressure fuel and electricity, therefore, safety precautions should be taken. Perform this test in a safe area and avoid any sparks and flames. Do not smoke.
Discharge the fuel system pressure (See page Engine / Hybrid System>2TR-FBE FUEL>FUEL SYSTEM>PRECAUTION).
Remove the fuel hose from the fuel pressure pulsation damper (See page Engine / Hybrid System>2TR-FBE FUEL>FUEL PRESSURE PULSATION DAMPER>REMOVAL).
Remove the fuel hose from the fuel filter (See page Engine / Hybrid System>2TR-FBE FUEL>FUEL FILTER>REPLACEMENT).
Disconnect the fuel pressure regulator (See page Engine / Hybrid System>2TR-FBE FUEL>FUEL PRESSURE REGULATOR>REMOVAL).
Do not disconnect the No. 2 fuel hose from the fuel pressure regulator.
| *1 | SST (3 Way) |
| *2 | SST (Hose) |
| *3 | SST (Union) |
| *4 | SST (Clip) |
| *5 | SST (Fuel Tube Connector) |
Assemble SST as shown in the illustration.
| *1 | SST (Fuel Tube Connector) |
| *2 | Fuel Filter |
Connect SST to the fuel filter.
| *1 | SST (Union) |
| *2 | Pressure Regulator |
Connect SST to the pressure regulator fuel inlet with the 2 bolts.
Make sure that the O-ring is installed to the pressure regulator.
Install the O-ring to the fuel injector.
| *1 | Vinyl Tube |
| *2 | SST (Clamp) |
| *3 | SST (Hose) |
| *4 | SST (Clip) |
| *5 | SST (Adaptor) |
Assemble SST as shown in the illustration.
Put the injector into a graduated cylinder.
Install a suitable vinyl tube onto the injector to contain the gasoline spray.
Operate the fuel pump.
| *1 | SST (Wire) |
|
Connect |
Connect SST (wire) to the injector and the battery for 15 seconds, and measure the injection volume with a graduated cylinder. Test each injector 2 or 3 times.
95 to 115 cm3 (5.8 to 7.0 cu. in.) in 5 seconds
20 cm3 (1.2 cu. in.) or less
If the result is not as specified, replace the fuel injector.
Check the fuel leakage.
In the condition above, disconnect the test probes of SST (wire) from the battery and check the fuel leakage from the injector.
1 drop or less per 12 minutes