Home › Engine / Hybrid System › 2TR-FBE FUEL › FUEL JET › 2012.01–2012.04
RM1840EF _51 Engine / Hybrid System _009581 2TR-FBE FUEL _0052251 FUEL JET A

2TR-FBE FUEL  FUEL JET  INSTALLATION  


PROCEDURE

Hide 1.INSTALL NO. 1 FUEL PIPE SUB-ASSEMBLY

a.

Apply gasoline to 4 new O-rings. Then install the 4 O-rings to the No. 1 fuel pipe sub-assembly.


b.
A241648
0.969,2.438 0.969,3.042 false 0.979,2.906 2.333,2.906 2.333,2.906 2.333,3.115 false 1.396,2.76 1.396,2.906 false 1.917,2.417 1.917,2.906 false 0.885,3.135 1.073,3.323 0.188,0.188 10 false *1
*1 Paint Mark (White)


Set the No. 1 fuel pipe sub-assembly against the 4 protrusions and install it with the 4 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:
·

Set the areas of the fuel pipe marked with white paint marks against the protrusions of the intake manifold from the directions indicated by the arrows in the illustration.

·

Make sure the fuel pipe does not become deformed when installing it.




c.

Connect the fuel hose.


Hide 2.INSTALL FUEL DELIVERY PIPE SUB-ASSEMBLY

Hide 3.INSPECT FOR FUEL LEAK (for Fuel Sub Tank)