Home › Engine / Hybrid System › 2TR-FBE FUEL › FUEL JET
RM1840EF _51 Engine / Hybrid System _009581 2TR-FBE FUEL _0052251 FUEL JET G

2TR-FBE FUEL  FUEL JET  INSPECTION  


PROCEDURE

Hide 1.INSPECT NO. 1 FUEL PIPE SUB-ASSEMBLY

a.

Visually check the jet of the No. 1 fuel pipe sub-assembly.

i.
A230920

Inspect the jet.

HINT:

The inner diameter of the jet is approximately 0.56 mm (0.0220 in.).



ii.
A239176
1.458,2.083 1.604,2.26 0.146,0.177 10 false A 0.781,0.76 0.927,0.938 0.146,0.177 10 false B 1.51,0.552 1.656,0.729 0.146,0.177 10 false B 2.354,0.229 2.5,0.406 0.146,0.177 10 false B 2.76,1.167 2.906,1.344 0.146,0.177 10 false B 1.51,4.406 1.656,4.583 0.146,0.177 10 false A 0.792,3.063 0.938,3.24 0.146,0.177 10 false B 1.542,2.833 1.688,3.01 0.146,0.177 10 false B 2.385,2.563 2.531,2.74 0.146,0.177 10 false B 2.813,3.323 2.958,3.5 0.146,0.177 10 false B

If the No. 1 fuel pipe sub-assembly passages are clogged or dirty, clean them. After blowing air in both directions (A and B) as indicated in the illustration, visually check the jet of the No. 1 fuel pipe sub-assembly again.

If the No. 1 fuel pipe sub-assembly passages remain clogged or dirty, replace the No. 1 fuel pipe sub-assembly.