1.DISCHARGE FUEL SYSTEM PRESSURE
2. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
4.DISCONNECT NO. 1 FUEL HOSE
| *1 | Fuel Hose Connector Cover |
Disconnect the No. 1 fuel hose (See page Engine / Hybrid System>2TR-FBE FUEL>FUEL SYSTEM>PRECAUTION).
5.REMOVE FUEL PRESSURE PULSATION DAMPER ASSEMBLY
Remove the 2 bolts and fuel pressure pulsation damper.