Home › Engine / Hybrid System › 2TR-FBE FUEL › FUEL PUMP(for Fuel Sub Tank) › 2012.04–2012.10
RM1840EF _51 Engine / Hybrid System _009581 2TR-FBE FUEL _0052258 FUEL PUMP(for Fuel Sub Tank) A

2TR-FBE FUEL  FUEL PUMP(for Fuel Sub Tank)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.DRAIN FUEL

Hide 4.REMOVE NO. 2 FUEL TUBE SUB-ASSEMBLY

a.
A237771

Disconnect the fuel pump connector.


b.
A237778

Detach the claw, then disconnect the No. 2 fuel tube sub-assembly.

HINT:
·

A filter is built in the No. 2 fuel tube.

·

If the No. 2 fuel tube is clogged, replace it with a new one.




Hide 5.REMOVE FUEL PUMP

a.
A237779

Pull out the fuel pump.


Hide 6.REMOVE CHECK VALVE GASKET

a.
A237780

Remove the check valve gasket.