1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
3.DRAIN FUEL
4.REMOVE NO. 2 FUEL TUBE SUB-ASSEMBLY
Disconnect the fuel pump connector.
Detach the claw, then disconnect the No. 2 fuel tube sub-assembly.
A filter is built in the No. 2 fuel tube.
If the No. 2 fuel tube is clogged, replace it with a new one.
5.REMOVE FUEL PUMP
Pull out the fuel pump.
6.REMOVE CHECK VALVE GASKET
Remove the check valve gasket.