Home › Engine / Hybrid System › 2TR-FBE FUEL › FUEL SENDER GAUGE ASSEMBLY(for Fuel Main Tank)
RM1840EF _51 Engine / Hybrid System _009581 2TR-FBE FUEL _0052261 FUEL SENDER GAUGE ASSEMBLY(for Fuel Main Tank) G

2TR-FBE FUEL  FUEL SENDER GAUGE ASSEMBLY(for Fuel Main Tank)  INSPECTION  


PROCEDURE

Hide 1.INSPECT FUEL SENDER GAUGE ASSEMBLY

a.
A237764
0.729,2.458 0.302,2.458 false 0.781,4.354 0.583,3.969 0.583,3.969 0.417,3.969 false 0.167,2.375 0.281,2.531 0.115,0.156 10 false F 0.24,3.885 0.375,4.063 0.135,0.177 10 false E 0.052,0.063 0.292,0.313 0.24,0.25 10 false *a
*a Front view of wire harness connector
(to Fuel Sender Gauge Assembly)


Check that the float moves smoothly between F and E.


b.

Measure the resistance between terminals 1 and 2 of the connector according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 F 13.5 to 16.5 Ω
Between E and F 13.5 to 418.2 Ω (Gradually changes)
E 401.8 to 418.2 Ω


HINT:

If the value is not as specified, replace the fuel sender gauge assembly.



c.

Install the fuel sender gauge assembly.