Home › Engine / Hybrid System › 2TR-FBE FUEL › FUEL SENDER GAUGE ASSEMBLY(for Fuel Sub Tank) › 2012.04–2012.10
RM1840EF _51 Engine / Hybrid System _009581 2TR-FBE FUEL _0052262 FUEL SENDER GAUGE ASSEMBLY(for Fuel Sub Tank) A

2TR-FBE FUEL  FUEL SENDER GAUGE ASSEMBLY(for Fuel Sub Tank)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.DRAIN FUEL

Hide 4.DISCONNECT NO. 4 FUEL HOSE

a.
A237770

Disconnect the fuel sender gauge connector.


b.
A237775

Disconnect the No. 4 fuel hose.


Hide 5.REMOVE FUEL SUCTION PLATE SUB-ASSEMBLY

a.
A238197

Remove the fuel pump gauge retainer.

NOTICE:

Perform this work by hand. Do not use any tools.



b.

Remove the fuel suction plate sub-assembly.


c.
A233435

Remove the fuel suction tube set gasket.