Home › Engine / Hybrid System › 2KD-FTV EMISSION CONTROL › EXHAUST FUEL ADDITION INJECTOR › from 2012.04
RM1840EF _51 Engine / Hybrid System _009583 2KD-FTV EMISSION CONTROL _0052281 EXHAUST FUEL ADDITION INJECTOR G

2KD-FTV EMISSION CONTROL  EXHAUST FUEL ADDITION INJECTOR  INSPECTION  


PROCEDURE

Hide 1.INSPECT EXHAUST FUEL ADDITION INJECTOR ASSEMBLY

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 7.1 to 7.9 Ω


HINT:

The temperature indicated under "Condition" is the temperature of the exhaust fuel addition injector assembly.


If the result is not as specified, replace the exhaust fuel addition injector assembly.