Home › Engine / Hybrid System › 1KD-FTV EMISSION CONTROL › VACUUM REGULATING VALVE
RM1840EF _51 Engine / Hybrid System _009584 1KD-FTV EMISSION CONTROL _0052289 VACUUM REGULATING VALVE G

1KD-FTV EMISSION CONTROL  VACUUM REGULATING VALVE  INSPECTION  


CAUTION / NOTICE / HINT

NOTICE:

Do not remove the electric vacuum regulating valve from the bracket.


PROCEDURE

Hide 1.INSPECT ELECTRIC VACUUM REGULATING VALVE ASSEMBLY (for EGR)

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 11 to 13 Ω
1 - Body ground
2 - Body ground
20°C (68°F) 10 kΩ or higher


If the result is not as specified, replace the electric EGR control valve assembly.


b.

Check the operation of the E-VRV.

i.

When a vacuum of 67 kPa (500 mmHg, 19.7 in.Hg) is applied to port F, check that air flows from port E to the filter.

A257090
2.417,0.594 2.708,0.823 2.708,0.823 2.813,0.823 true 0.906,0.115 1,0.115 1,0.115 1.302,0.833 true 0.865,0.406 0.958,0.406 0.958,0.406 1.156,0.854 true 6.198,0.667 6.292,0.313 6.292,0.313 6.396,0.313 true 5.417,0.448 5.313,0.448 5.313,0.448 5.146,0.833 true 4.99,0.896 4.469,0.896 true 0.729,0.042 0.917,0.198 0.188,0.156 10 false *1 0.688,0.344 0.875,0.5 0.188,0.156 10 false *2 1.281,2.229 1.469,2.385 0.188,0.156 10 false *b 2.094,1.896 2.281,2.052 0.188,0.156 10 false *a 2.833,0.75 3.021,0.906 0.188,0.156 10 false *3 5.438,0.385 5.625,0.542 0.188,0.156 10 false *1 4.313,0.813 4.5,0.969 0.188,0.156 10 false *2 5.115,2.115 5.302,2.271 0.188,0.156 10 false *b 5.5,0.094 5.688,0.25 0.188,0.156 10 false *a 6.438,0.25 6.625,0.406 0.188,0.156 10 false *3 0.219,0.052 0.406,0.208 0.188,0.156 10 false *A 3.802,0.042 3.99,0.198 0.188,0.156 10 false *B
*A w/ EGR Cooler *B w/o EGR Cooler
*1 Port E *2 Port F
*3 Filter - -
*a Air *b Vacuum



ii.
A257091
0.365,0.51 0.479,0.51 0.479,0.51 0.625,1.042 true 1.167,0.104 1.052,0.104 1.052,0.104 0.792,0.99 true 1.052,2.906 0.938,2.906 0.938,2.906 0.698,3.302 true 0.49,3.313 0.24,3.313 true 1.208,0.021 1.396,0.177 0.188,0.156 10 false *1 0.156,0.427 0.344,0.583 0.188,0.156 10 false *2 1.865,1.969 2.052,2.125 0.188,0.156 10 false *a 1.167,2.396 1.354,2.552 0.188,0.156 10 false *a 1.073,2.823 1.26,2.979 0.188,0.156 10 false *1 0.031,3.219 0.219,3.375 0.188,0.156 10 true *2 0.042,0.042 0.229,0.198 0.188,0.156 10 false *A 0.042,2.354 0.229,2.51 0.188,0.156 10 false *B
*A w/ EGR Cooler
*B w/o EGR Cooler
*1 Port E
*2 Port F
*a Air


Apply battery voltage across terminals 1 and 2.


iii.

Check that air flows from port E to port F.

If the result is not as specified, replace the electric EGR control valve assembly.