1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
3.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
4.DRAIN ENGINE COOLANT
5.REMOVE TURBINE OUTLET ELBOW
6.REMOVE EXHAUST FUEL ADDITION INJECTOR ASSEMBLY
| *1 | Injector Holder |
| *2 | No. 1 Nozzle Holder Clamp |
| *3 | Exhaust Fuel Addition Injector |
| *4 | E-Ring |
| *5 | No. 3 Backup Ring |
| *6 | O-Ring |
| *7 | No. 2 Backup Ring |
| *8 | No. 1 Backup Ring |
| *9 | Gasket |
Remove the 2 bolts and injector holder.
Using a T40 "TORX" socket wrench, remove the screw, washer and No. 1 nozzle holder clamp.
Remove the exhaust fuel addition injector and gasket.
Remove the E-ring, O-ring and 3 backup rings from the exhaust fuel addition injector.