Home › Engine / Hybrid System › 2TR-FE EMISSION CONTROL › AIR SWITCHING VALVE(w/ Secondary Air Injection System)
RM1840EF _51 Engine / Hybrid System _009585 2TR-FE EMISSION CONTROL _0052301 AIR SWITCHING VALVE(w/ Secondary Air Injection System) A

2TR-FE EMISSION CONTROL  AIR SWITCHING VALVE(w/ Secondary Air Injection System)  INSTALLATION  


PROCEDURE

Hide 1.INSTALL AIR SWITCHING VALVE ASSEMBLY

a.

Install the air switching valve assembly with 2 new nuts.

Torque:
20 N*m (204 kgf*cm, 15 ft.*lbf)


b.

Connect the air switching valve connector.


Hide 2.INSTALL NO. 4 INTAKE PIPE

a.
A301904
1.615,0.302 1.771,0.5 0.156,0.198 10 false 3 2.75,0.531 2.906,0.729 0.156,0.198 10 false 1 0.948,1.573 1.104,1.771 0.156,0.198 10 false 4 1.646,1.573 1.802,1.771 0.156,0.198 10 false 2

Install 2 new gaskets and the No. 4 intake pipe with 4 new nuts and tighten the nuts in the order shown in the illustration. Then, tighten the nuts labeled 1 and 3 to the torque specification again.

Torque:
20 N*m (204 kgf*cm, 15 ft.*lbf)


b.

Check that the nuts are tightened to the torque specification.


Hide 3.INSTALL NO. 1 EXHAUST MANIFOLD HEAT INSULATOR

a.

Install the heat insulator with the 5 bolts.

Torque:
12 N*m (122 kgf*cm, 9 ft.*lbf)


Hide 4.CONNECT NO. 4 AIR INJECTION SYSTEM HOSE

a.

Connect the No. 4 air injection system hose to the air switching valve.


b.

Secure the hose with the clamp.