Home › Engine / Hybrid System › 2TR-FE EMISSION CONTROL › AIR SWITCHING VALVE(w/ Secondary Air Injection System)
RM1840EF _51 Engine / Hybrid System _009585 2TR-FE EMISSION CONTROL _0052301 AIR SWITCHING VALVE(w/ Secondary Air Injection System) G

2TR-FE EMISSION CONTROL  AIR SWITCHING VALVE(w/ Secondary Air Injection System)  INSPECTION  


PROCEDURE

Hide 1.INSPECT AIR SWITCHING VALVE ASSEMBLY

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 4.5 to 5.5 Ω
1 - Body ground Always 1 MΩ or higher
2 - Body ground


HINT:

When measuring the resistance, make sure that the surface temperature of the air switching valve is 20°C (68°F).


If the result is not as specified, replace the air switching valve assembly.


b.
A303017
2.427,1.385 2.594,1.719 2.594,1.719 2.833,1.719 true 0.74,1.646 0.646,1.156 0.646,1.156 0.458,1.156 true 2.875,1.625 3.083,1.823 0.208,0.198 10 false *1 0.25,1.073 0.438,1.24 0.188,0.167 10 false *2 2.563,0.583 2.781,0.781 0.219,0.198 10 false *a
*1 Port A
*2 Port B
*a Air


Check operation of the air switching valve.

i.

Check that air does not flow from port A to port B.

If the result is not as specified, replace the air switching valve assembly.


ii.
A110279
0.729,1.438 0.344,1.438 true 1.427,1.448 1.042,1.448 true 2.917,3.99 2.781,3.99 2.781,3.99 2.448,3.594 true 0.969,3.865 0.76,3.354 0.76,3.354 0.594,3.354 true 0.188,1.385 0.448,1.573 0.26,0.188 10 false 1 1.5,1.375 1.75,1.542 0.25,0.167 10 false 2 2.635,2.76 2.865,2.927 0.229,0.167 10 false *a 0.375,3.292 0.635,3.469 0.26,0.177 10 false *2 2.979,3.906 3.208,4.083 0.229,0.177 10 false *1
*1 Port A
*2 Port B
*a Air


Apply battery voltage across terminals 1 and 2.


iii.

Check that air flows from port A to port B.

If the result is not as specified, replace the air switching valve assembly.