Home › Engine / Hybrid System › 2TR-FE EMISSION CONTROL › PURGE VALVE
RM1840EF _51 Engine / Hybrid System _009585 2TR-FE EMISSION CONTROL _0052304 PURGE VALVE G

2TR-FE EMISSION CONTROL  PURGE VALVE  INSPECTION  


PROCEDURE

Hide 1.INSPECT PURGE VSV

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 26 to 30 Ω
1 - Body ground Always 10 MΩ or higher
2 - Body ground


HINT:

When measuring the coil resistance, make sure that the surface temperature of the purge VSV is 20°C (68°F).


If the result is not as specified, replace the purge VSV.


b.
A303018
1.844,0.792 1.958,0.667 1.958,0.667 2.177,0.667 false 2.135,1.313 2.25,1.646 2.25,1.646 2.406,1.646 false 2.646,0.208 2.823,0.375 0.177,0.167 10 false *a 2.208,0.583 2.406,0.75 0.198,0.167 10 false *1 2.438,1.542 2.635,1.708 0.198,0.167 10 false *2
*1 Port E
*2 Port F
*a Air


Check operation of the purge VSV.

i.

Check that air does not flow from port E to port F.


ii.
A110272
0.615,1.667 1.063,1.667 false 0.802,2.719 0.802,2.427 false 0.385,1.615 0.563,1.781 0.177,0.167 10 false *1 0.729,2.802 1.01,2.948 0.281,0.146 10 false *2 1.802,0.635 2.083,0.833 0.281,0.198 10 false *a
*1 Port E
*2 Port F
*a Air


Apply battery voltage across terminals 1 and 2.


iii.

Check that air flows from port E to port F.

If the result is not as specified, replace the purge VSV.