Home › Engine / Hybrid System › 1KD-FTV INTAKE / EXHAUST › EXHAUST MANIFOLD W/ TURBOCHARGER(w/o DPF) › 2011.10–2012.01
RM1840EF _51 Engine / Hybrid System _009588 1KD-FTV INTAKE / EXHAUST _0052321 EXHAUST MANIFOLD W/ TURBOCHARGER(w/o DPF) A

1KD-FTV INTAKE / EXHAUST  EXHAUST MANIFOLD W/ TURBOCHARGER(w/o DPF)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 4.REMOVE FRONT WHEEL RH

Hide 5.REMOVE NO. 1 ENGINE UNDER COVER

Hide 6.REMOVE NO. 2 ENGINE UNDER COVER

Hide 8.REMOVE FRONT FENDER APRON SEAL UPPER

a.

Remove the 5 clips and front fender apron seal upper.


Hide 9.REMOVE FRONT FENDER SEAL

a.

Remove the 5 clips and front fender seal.


Hide 12.REMOVE VENTILATION PIPE

a.
A211832

Remove the bolt and disconnect the 2 ventilation hoses and ventilation pipe.


Hide 13.REMOVE COMPRESSOR INLET ELBOW

a.
A211833

Disconnect the 2 connectors from the turbocharger.


b.

Detach the wire harness clamp.


c.

Remove the 2 nuts, compressor inlet elbow and gasket.


Hide 14.REMOVE NO. 1 TURBO INSULATOR

a.
A255740

Remove the 2 bolts and No. 1 turbo insulator.


Hide 15.REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR

a.
A255741

Remove the bolt and No. 1 exhaust manifold heat insulator.


Hide 16.REMOVE NO. 1 TURBO WATER HOSE

a.
A211835

Remove the 2 No. 1 turbo water hoses.


Hide 17.REMOVE TURBINE OUTLET ELBOW

a.
A211836

Remove the 3 nuts, turbine outlet elbow and gasket.


Hide 18.REMOVE TURBOCHARGER STAY

a.
A211837

Remove the 2 bolts, nut and turbocharger stay.


Hide 19.REMOVE TURBO OIL INLET PIPE SUB-ASSEMBLY

a.
A301790
0.938,0.948 1.219,1.198 0.281,0.25 10 false A

Remove the 2 bolts, 2 nuts, union bolt, turbo oil inlet pipe and 3 gaskets.

NOTICE:

Do not loosen the nut labeled A.



Hide 20.REMOVE TURBOCHARGER SUB-ASSEMBLY

a.
A211839

Remove the 3 nuts, turbocharger and gasket.


Hide 21.REMOVE EXHAUST MANIFOLD

a.
A252010

Remove the 8 nuts, 8 plate washers, 8 collars and exhaust manifold.


b.

Remove the gasket.


Hide 22.REMOVE NO. 1 TURBO WATER PIPE SUB-ASSEMBLY

a.
A211906

Remove the 2 nuts, bolt, No. 1 turbo water pipe and gasket.