Home › Engine / Hybrid System › 1KD-FTV INTAKE / EXHAUST › EXHAUST PIPE(w/o DPF)
RM1840EF _51 Engine / Hybrid System _009588 1KD-FTV INTAKE / EXHAUST _0052323 EXHAUST PIPE(w/o DPF) A

1KD-FTV INTAKE / EXHAUST  EXHAUST PIPE(w/o DPF)  INSTALLATION  


PROCEDURE

Hide 1.INSTALL FRONT EXHAUST PIPE ASSEMBLY

a.
A111834

Using a vernier caliper, measure the free length of the compression spring.

Minimum length:

40 mm (1.57 in.)


If the free length is less than the minimum, replace the compression spring.


b.

Install the front exhaust pipe to the exhaust pipe support.


c.
A111803
2.844,0.677 2.271,0.271 2.271,0.271 2.156,0.271 true 2.865,1.052 2.865,1.448 true 1.917,0.177 2.177,0.406 0.26,0.229 10 false *1 2.792,1.51 3.021,1.74 0.229,0.229 10 false *2
*1 Gasket
*2 Turbine Outlet Elbow


Install a new gasket to the turbine outlet elbow.

NOTICE:
·

Be careful with the installation direction of the gasket.


·

Do not reuse the gasket.


·

To ensure a proper seal, do not use the front exhaust pipe to force the gasket onto the turbine outlet elbow.



HINT:

Using a plastic-faced hammer, uniformly strike the gasket so that the gasket and outlet pipe are properly fit.



d.

Install the front exhaust pipe and 2 compression springs with the 2 bolts. Alternately tighten the bolts in several passes.

Torque:
43 N*m (438 kgf*cm, 32 ft.*lbf)


Hide 2.INSTALL CENTER EXHAUST PIPE ASSEMBLY

a.

Install the center exhaust pipe to the 3 exhaust pipe supports.


b.

Install a new gasket and connect the center exhaust pipe to the front exhaust pipe with the 2 bolts and 2 nuts. Alternately tighten the bolts in several passes.

Torque:
48 N*m (489 kgf*cm, 35 ft.*lbf)

NOTICE:

Do not reuse the gasket.



Hide 3.INSTALL TAILPIPE ASSEMBLY

a.

Install the tailpipe to the exhaust pipe support.


b.

Install a new gasket and connect the tailpipe to the center exhaust pipe with the 2 bolts and 2 nuts. Alternately tighten the bolts in several passes.

Torque:
48 N*m (489 kgf*cm, 35 ft.*lbf)

NOTICE:

Do not reuse the gasket.



Hide 4.INSPECT FOR EXHAUST GAS LEAK

If gas is leaking, tighten the problem areas to stop the leak. Replace damaged parts as necessary.