Home › Engine / Hybrid System › 1KD-FTV INTAKE / EXHAUST › INTAKE MANIFOLD(w/ Glow Plug Controller) › 2012.04–2012.10
RM1840EF _51 Engine / Hybrid System _009588 1KD-FTV INTAKE / EXHAUST _0052328 INTAKE MANIFOLD(w/ Glow Plug Controller) A

1KD-FTV INTAKE / EXHAUST  INTAKE MANIFOLD(w/ Glow Plug Controller)  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the injectors (including shuffling the injectors between the cylinders), common rail or cylinder head, it is necessary to replace the injection pipes with new ones.

·

When replacing the fuel supply pump, common rail, cylinder block, cylinder head, cylinder head gasket or timing gear case, it is necessary to replace the fuel inlet pipe with a new one.

·

After removing the injection pipes and fuel inlet pipe, clean them with a brush and compressed air.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.REMOVE ELECTRIC EGR CONTROL VALVEASSEMBLY WITH NO. 2 EGR VALVEAND EGR COOLER

Hide 7.REMOVE NO. 1 VACUUM SWITCHING VALVE ASSEMBLY (for DPF)

Hide 11.REMOVE NO. 3 INTERCOOLER SUPPORT BRACKET

a.
A271957

Remove the bolt and No. 3 intercooler support bracket.


Hide 15.REMOVE INTAKE MANIFOLD INSULATOR

A245459

Hide 17.REMOVE VACUUM SWITCHING VALVE ASSEMBLY (for i-ART)

a.
A271927

Disconnect the 4 vacuum hoses.


b.
A271925

Remove the 2 screws, No. 1 vacuum switching valve and No. 2 vacuum switching valve.


Hide 18.REMOVE INTAKE MANIFOLD

a.
A254201

for DPF:

Disconnect the vacuum hose.


b.
A245461

Detach the sensor wire connector clamp from the intake manifold.


c.
A271833

Remove the 4 bolts, 2 nuts, intake manifold and gasket.