Home › Engine / Hybrid System › 2TR-FE INTAKE / EXHAUST › EXHAUST MANIFOLD
RM1840EF _51 Engine / Hybrid System _009589 2TR-FE INTAKE / EXHAUST _0052336 EXHAUST MANIFOLD A

2TR-FE INTAKE / EXHAUST  EXHAUST MANIFOLD  REMOVAL  


PROCEDURE

Hide 1.REMOVE FRONT UPPER FENDER APRON SEAL

a.

Remove the 5 clips and front upper fender apron seal.


Hide 2.REMOVE FRONT FENDER SEAL

a.

Remove the 5 clips and front fender seal.


Hide 3.REMOVE AIR CLEANER ASSEMBLY (w/o Secondary Air Injection System)

a.
A253352

Disconnect the mass air flow meter connector.


b.

Loosen the hose clamp.


c.

Remove the 2 bolts and air cleaner assembly.


Hide 4.REMOVE AIR SWITCHING VALVE ASSEMBLY (w/ Secondary Air Injection System)

Hide 5.REMOVE FRONT EXHAUST PIPE ASSEMBLY

a.

w/ Secondary Air Injection System:

Disconnect the air fuel ratio sensor connector and detach the wire harness clamp.


b.

Disconnect the heated oxygen sensor connector and detach the wire harness clamp.


c.

Remove the 4 bolts, 2 nuts and 2 compression springs.


d.

Remove the front exhaust pipe from the exhaust pipe support.


Hide 6.REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR (w/o Secondary Air Injection System)

a.

Remove the 5 bolts and No. 1 exhaust manifold heat insulator.


Hide 7.REMOVE MANIFOLD STAY

a.
A252719

Remove the 3 bolts and manifold stay.


Hide 8.REMOVE EXHAUST MANIFOLD

a.
A251810

w/o Secondary Air Injection System:

Remove the 6 nuts and exhaust manifold.


b.
A251804

w/ Secondary Air Injection System:

Remove the 8 nuts and exhaust manifold.


c.

Remove the gasket.