When replacing the injectors (including shuffling the injectors between the cylinders), common rail or cylinder head, it is necessary to replace the injection pipes with new ones.
When replacing the fuel supply pump, common rail, cylinder block, cylinder head, cylinder head gasket or timing gear case, it is necessary to replace the fuel inlet pipe with a new one.
After removing the injection pipes, clean them with a brush and compressed air.
1.INSTALL INTAKE MANIFOLD
Temporarily install a new gasket and the intake manifold with the 4 bolts and 2 nuts.
Tighten the 4 bolts and 2 nuts in the order shown in the illustration.
| *1 | No. 1 manifold insulator |
When installing the intake manifold, make sure that the No. 1 manifold insulator is not pinched.
Make sure that the swirl control valve actuator is not damaged by surrounding parts.
Connect the vacuum hose and connector to the vacuum switching valve.
2.INSTALL INTAKE MANIFOLD INSULATOR
| *1 | Intake Manifold |
| *2 | Intake Manifold Insulator |
| *3 | Common Rail |
Install the intake manifold insulator with the 2 bolts.
3.INSTALL NO. 3 INTERCOOLER SUPPORT BRACKET
Install the No. 3 intercooler support bracket with the bolt.
4.INSTALL NO. 2 NOZZLE LEAKAGE PIPE ASSEMBLY
5.INSTALL NO. 4 INJECTION PIPE SUB-ASSEMBLY
6.TEMPORARILY INSTALL ELECTRIC EGR CONTROL VALVE WITH NO. 2 EGR VALVE AND EGR COOLER
7.INSTALL ENGINE OIL LEVEL DIPSTICK GUIDE
Install a new O-ring to the engine oil level dipstick guide.
Apply a small amount of clean engine oil to the O-ring.
Install the engine oil level dipstick guide with the bolt.
Install the injection pipe clamp with the bolt.
Install the engine oil level dipstick.
8.INSTALL MANIFOLD STAY WITH VACUUM SWITCHING VALVE
Install the manifold stay with vacuum switching valve with the 2 bolts.
Be sure to securely connect the vacuum transmitting hose.
Connect the 3 vacuum transmitting hoses and 2 vacuum switching valve connector.
9.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
10.ADD ENGINE COOLANT
11.BLEED AIR FROM FUEL SYSTEM
12.INSPECT FOR COOLANT LEAK
13.INSPECT FOR FUEL LEAK
14.INSPECT FOR OIL LEAK
15.INSPECT ENGINE OIL LEVEL
16.INSTALL NO. 1 ENGINE UNDER COVER