Home › Engine / Hybrid System › 2KD-FTV INTAKE / EXHAUST › INTAKE MANIFOLD(for DPF) › 2012.04–2012.10
RM1840EF _51 Engine / Hybrid System _009590 2KD-FTV INTAKE / EXHAUST _0052346 INTAKE MANIFOLD(for DPF) A

2KD-FTV INTAKE / EXHAUST  INTAKE MANIFOLD(for DPF)  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the injectors (including shuffling the injectors between the cylinders), common rail or cylinder head, it is necessary to replace the injection pipes with new ones.

·

When replacing the fuel supply pump, common rail, cylinder block, cylinder head, cylinder head gasket or timing gear case, it is necessary to replace the fuel inlet pipe with a new one.

·

After removing the injection pipes and fuel inlet pipe, clean them with a brush and compressed air.



PROCEDURE

Hide 1.INSTALL INTAKE MANIFOLD

a.
A301880
0.625,1.948 0.781,2.146 0.156,0.198 10 false 1 3.177,0.708 3.333,0.906 0.156,0.198 10 false 2 1.656,1.927 1.813,2.125 0.156,0.198 10 false 3 2.854,1.917 3.01,2.115 0.156,0.198 10 false 4 2.24,1.771 2.396,1.969 0.156,0.198 10 false 5 1.063,1.76 1.219,1.958 0.156,0.198 10 false 6

Temporarily install a new gasket and the intake manifold with the 4 bolts and 2 nuts.


b.

Tighten the 4 bolts and 2 nuts in the order shown in the illustration.

Torque:
29 N*m (296 kgf*cm, 21 ft.*lbf)


c.

Attach the sensor wire connector clamp.


d.

Connect the fuel hose protector to the intake manifold and install the bolt.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


Hide 2.INSTALL INTAKE MANIFOLD INSULATOR

Hide 3.INSTALL NO. 1 INTAKE MANIFOLD INSULATOR

Hide 6.INSTALL NO. 3 INTERCOOLER SUPPORT BRACKET

a.

Install the No. 3 intercooler support bracket with the bolt.

Torque:
23 N*m (235 kgf*cm, 17 ft.*lbf)


Hide 8.INSTALL NO. 2 NOZZLE LEAKAGE PIPE ASSEMBLY

Hide 11.CONNECT WIRING HARNESS CLAMP BRACKET

Hide 12.INSTALL NO. 4 INJECTION PIPE SUB-ASSEMBLY

Hide 13.INSTALL ELECTRIC EGR CONTROL VALVE ASSEMBLY WITH NO. 2 EGR VALVE AND EGR COOLER

Hide 14.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).