Home › Engine / Hybrid System › 2TR-FBE INTAKE / EXHAUST › EXHAUST MANIFOLD
RM1840EF _51 Engine / Hybrid System _009591 2TR-FBE INTAKE / EXHAUST _0052352 EXHAUST MANIFOLD A

2TR-FBE INTAKE / EXHAUST  EXHAUST MANIFOLD  REMOVAL  


PROCEDURE

Hide 1.REMOVE FRONT UPPER FENDER APRON SEAL

a.

Remove the 5 clips and front upper fender apron seal.


Hide 2.REMOVE FRONT FENDER SEAL

a.

Remove the 5 clips and front fender seal.


Hide 3.REMOVE AIR SWITCHING VALVE ASSEMBLY

Hide 4.REMOVE FRONT EXHAUST PIPE ASSEMBLY

a.

Disconnect the air fuel ratio sensor connector and detach the wire harness clamp.


b.

Disconnect the heated oxygen sensor connector and detach the wire harness clamp.


c.

Remove the 4 bolts, 2 nuts and 2 compression springs.


d.

Remove the front exhaust pipe from the exhaust pipe support.


Hide 5.REMOVE MANIFOLD STAY

a.
A252719

Remove the 3 bolts and manifold stay.


Hide 6.REMOVE EXHAUST MANIFOLD

a.
A250369

Remove the 8 nuts and exhaust manifold.


b.

Remove the gasket.