Home › Engine / Hybrid System › 1KD-FTV COOLING › WATER PUMP(w/o Glow Plug Controller)
RM1840EF _51 Engine / Hybrid System _009593 1KD-FTV COOLING _0052361 WATER PUMP(w/o Glow Plug Controller) G

1KD-FTV COOLING  WATER PUMP(w/o Glow Plug Controller)  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT FOR COOLANT LEAK

HINT:
·

The sliding surface inside the engine water pump assembly is lubricated by engine coolant. As some engine coolant is discharged during normal operation, coolant residue (solids) may be found on the drain plug or the bottom of the engine water pump assembly. Engine coolant may leak if foreign matter enters the engine water pump assembly, however the sealing performance will recover when the foreign matter is pushed out or breaks into fine pieces.

·

Before performing this inspection, check that there is no coolant leaking from any parts other than the engine water pump assembly. If there are leaks, inspect those areas.

·

Perform this inspection when the engine is cold.



a.

Visually check the engine water pump assembly.

i.

Check that engine coolant is not dripping from the engine water pump assembly.

HINT:
·

If engine coolant is dripping, replace the engine water pump assembly.

·

If engine coolant is not dripping, perform the following check.





Hide 3.INSPECT ENGINE WATER PUMP ASSEMBLY

a.
A224945
0.781,1.052 1.021,1.219 0.24,0.167 10 true *1 2.198,0.479 2.458,0.656 0.26,0.177 10 true *2
*1 Water Hole
*2 Air Hole


Visually check the water hole and air hole for coolant leakage.

If leakage is found, replace the engine water pump assembly.


b.

Turn the pulley and check that the pump bearing moves smoothly and quietly.

If the bearing moves roughly or noisily, replace the engine water pump assembly.


Hide 4.INSPECT FLUID COUPLING ASSEMBLY

a.
A112113

Remove the 4 nuts and fan.


b.
A097646

Check the fluid coupling for damage or silicon oil leaks. If necessary, replace the fluid coupling.


c.

Install the fan with the 4 nuts.

Torque:
6.0 N*m (61 kgf*cm, 53 in.*lbf)