1.INSTALL ENGINE WATER PUMP ASSEMBLY
|
Bolt A |
|
Bolt B |
Install a new gasket and the engine water pump assembly with the 10 bolts.
2.INSTALL V-RIBBED BELT TENSIONER ASSEMBLY
|
Bolt A |
|
Bolt B |
|
Bolt C |
Temporarily install the belt tensioner with the 3 bolts.
Make sure the flanges of the bolts are contacting the tensioner surface.
Install the tensioner with the 3 bolts.
3.INSTALL NO. 1 IDLER PULLEY SUB-ASSEMBLY
| *1 | Spacer |
| *2 | Pulley |
Install the spacer and pulley with the bolt.
4.INSTALL ENGINE OIL LEVEL DIPSTICK GUIDE
Install a new O-ring and the engine oil level dipstick guide with the bolt.
Install the engine oil level dipstick.
5.INSTALL GENERATOR ASSEMBLY
6.INSTALL FAN SHROUD
Install the fan pulley to the engine water pump.
Place the shroud together with the fluid coupling fan between the radiator and engine.
Be careful not to damage the radiator core.
Install the coupling fan to the engine water pump with the 4 nuts. Tighten the nuts as much as possible by hand.
Attach the claws of the shroud to the radiator as shown in the illustration.
Install the shroud with the 2 bolts.
Install the fan and generator V belt (See page Engine / Hybrid System>2TR-FE ENGINE MECHANICAL>DRIVE BELT>INSTALLATION).
Tighten the 4 nuts of the fluid coupling fan.
Connect the reservoir hose to the upper radiator tank.
7.INSTALL AIR PUMP INLET (w/ Secondary Air Injection System)
Install the air pump inlet to the upper radiator tank with the bolt.
8.CONNECT RADIATOR HOSE OUTLET
9.CONNECT RADIATOR HOSE INLET
10.ADD ENGINE COOLANT
11.INSPECT FOR COOLANT LEAK
12.INSTALL NO. 1 ENGINE UNDER COVER