1.REMOVE NO. 1 ENGINE UNDER COVER
2.DRAIN ENGINE COOLANT
3.REMOVE INTERCOOLER ASSEMBLY WITH INTAKE AIR CONNECTOR (w/ EGR Cooler)
w/ DPF: (See Page Engine / Hybrid System>2KD-FTV INTAKE / EXHAUST>INTERCOOLER(w/ DPF)>REMOVAL)
w/o DPF: (See Page Engine / Hybrid System>2KD-FTV INTAKE / EXHAUST>INTERCOOLER(w/o DPF)>REMOVAL)
4.REMOVE VENTILATION HOSE HEAT INSULATOR (w/o EGR Cooler)
5.REMOVE AIR CLEANER ASSEMBLY
6.REMOVE VENTILATION PIPE (w/ EGR Cooler)
7.REMOVE COMPRESSOR INLET ELBOW (w/ EGR Cooler)
8.REMOVE COMPRESSOR INLET ELBOW (for DPF)
9.DISCONNECT RADIATOR HOSE OUTLET
Disconnect the radiator hose outlet from the water inlet.
10.REMOVE WATER INLET
Disconnect the wire harness clamp.
Remove the 3 bolts and water inlet.
Remove the bolt and wire harness clamp bracket from the water inlet.
11.REMOVE THERMOSTAT
Remove the thermostat from the cylinder block.
Remove the gasket from the thermostat.