Home › Engine / Hybrid System › 2KD-FTV COOLING › RADIATOR
RM1840EF _51 Engine / Hybrid System _009595 2KD-FTV COOLING _0052374 RADIATOR A

2KD-FTV COOLING  RADIATOR  DISASSEMBLY  


PROCEDURE

Hide 1.REMOVE RADIATOR BRACKET SUB-ASSEMBLY

a.
A099949

Remove the 4 bolts and 2 brackets.


Hide 2.REMOVE RADIATOR DRAIN COCK PLUG

a.

Remove the drain plug.


b.

Remove the O-ring.


Hide 3.ASSEMBLE SST

a.
A113337
2.823,1.104 2.396,1.74 2.396,1.74 2.302,1.74 true 2.385,0.708 2.688,0.281 2.688,0.281 2.781,0.281 false 2.208,2.781 2.406,3.042 2.406,3.042 2.5,3.042 false 0.5,2.51 0.719,2.958 0.719,2.958 0.802,2.958 false 2.865,0.208 3.125,0.375 0.26,0.167 10 false *2 2.104,1.677 2.344,1.833 0.24,0.156 10 false *3 0.375,1.365 0.604,1.51 0.229,0.146 10 false *1 0.885,2.885 1.188,3.052 0.302,0.167 10 false SST 2.573,2.948 2.875,3.115 0.302,0.167 10 false SST
*1 Dimension B
*2 Part A
*3 Stopper Bolt


Install the claw to part A of the overhaul handle as shown in the illustration.

SST
09230-01010  (09231-01010, 09231-01030)


b.

While squeezing the handle, adjust the stopper bolt so that dimension B is as specified below.

Dimension B:

0.2 to 0.3 mm (0.00787 to 0.0118 in.)


NOTICE:

If this adjustment is not performed, the claw will be damaged.



Hide 4.UNCAULK LOCK PLATE

a.
A113338
0.594,1 0.885,1.5 0.885,1.5 0.969,1.5 true 1.24,0.76 1.479,0.469 1.479,0.469 1.625,0.469 false 0.771,0.688 1.042,0.188 1.042,0.188 1.156,0.188 false 1.219,0.135 1.385,0.281 0.167,0.146 10 false *1 1.719,0.396 2.052,0.552 0.333,0.156 10 false SST 1.021,1.427 1.208,1.604 0.188,0.177 10 false *2
*1 Tank
*2 Lock Plate


Using SST to release the caulking, squeeze the handle until stopped by the stopper bolt.

SST
09230-01010  (09231-01010, 09231-01030)


Hide 5.REMOVE UPPER RADIATOR TANK AND LOWER RADIATOR TANK

a.
A099688

Lightly tap the bracket of the radiator (or radiator hose inlet or outlet) with a plastic-faced hammer and remove the tanks.


b.

Remove the O-ring.