Home › Engine / Hybrid System › 1GR-FE COOLING › THERMOSTAT › from 2012.04
RM1840EF _51 Engine / Hybrid System _009597 1GR-FE COOLING _0052384 THERMOSTAT G

1GR-FE COOLING  THERMOSTAT  INSPECTION  


PROCEDURE

Hide 1.INSPECT WATER INLET SUB-ASSEMBLY WITH THERMOSTAT

A075918

HINT:

The valve opening temperature is inscribed on the thermostat.


a.

Immerse the thermostat in the water, then heat the water gradually.


b.

Check the valve opening temperature of the thermostat.

Standard valve opening temperature:

80 to 84°C (176 to 183°F)


If the valve opening temperature is not as specified, replace the water inlet sub-assembly with thermostat.


c.
A075920
2.458,1.625 2.635,1.792 0.177,0.167 10 false *1
*1 Valve Lift


Check the valve lift.

Standard valve lift:

8.0 mm (0.315 in.) or more at 95°C (203°F)


If the valve lift is not as specified, replace the water inlet sub-assembly with thermostat.


d.

Check that the valve is fully closed when the thermostat is at low temperature (below 40°C (104°F)).

If not fully closed, replace the water inlet sub-assembly with thermostat.