When replacing the injectors (including shuffling the injectors between the cylinders), common rail or cylinder head, it is necessary to replace the injection pipes with new ones.
When replacing the fuel supply pump, common rail, cylinder block, cylinder head, cylinder head gasket or timing gear case, it is necessary to replace the fuel inlet pipe with a new one.
After removing the injection pipes, clean them with a brush and compressed air.
1.INSTALL OIL COOLER ASSEMBLY
Install 2 new gaskets to the oil cooler.
Install the oil cooler to the oil cooler cover with the 4 nuts.
2.INSTALL OIL COOLER COVER SUB-ASSEMBLY
Install a new gasket and the oil cooler cover with the 13 bolts.
Connect the No. 2 vacuum transmitting pipe with the 2 nuts.
Connect the oil pressure switch connector.
3.INSTALL OIL FILTER SUB-ASSEMBLY
4.INSTALL STARTER ASSEMBLY
5.INSTALL FUEL SUPPLY PUMP ASSEMBLY
6.INSTALL COMMON RAIL ASSEMBLY
8.BLEED AIR FROM FUEL SYSTEM
9.ADD ENGINE COOLANT
10.INSPECT FOR COOLANT LEAK
11.INSPECT FOR FUEL LEAK
12.INSPECT FOR OIL LEAK
13.INSTALL NO. 1 ENGINE UNDER COVER