Home › Engine / Hybrid System › 1KD-FTV LUBRICATION › LUBRICATION SYSTEM › 2011.10–2012.04
RM1840EF _51 Engine / Hybrid System _009600 1KD-FTV LUBRICATION _0052397 LUBRICATION SYSTEM G

1KD-FTV LUBRICATION  LUBRICATION SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT OIL QUALITY

a.

Check the engine oil for deterioration, water contamination, discoloration or thinning.

If the quality is visibly poor, replace the engine oil and oil filter (See page Engine / Hybrid System>1KD-FTV LUBRICATION>OIL AND OIL FILTER>REPLACEMENT).


Hide 2.INSPECT ENGINE OIL LEVEL

a.

Warm up the engine, stop the engine and wait 5 minutes. The engine oil level should be between the dipstick low level mark and full level mark.

If low, check for leakage and add oil up to the full level mark.

NOTICE:

Do not fill engine oil above the full level mark.



Hide 3.INSPECT ENGINE OIL PRESSURE

a.

Remove the engine oil pressure switch (See page Engine / Hybrid System>1KD-FTV LUBRICATION>OIL PRESSURE SWITCH>REMOVAL).


b.
A251774
2.854,0.552 2.948,0.24 2.948,0.24 3.021,0.24 false 1.719,0.823 1.208,0.823 true 3.083,0.125 3.271,0.313 0.188,0.188 10 false *1 1.042,0.719 1.229,0.906 0.188,0.188 10 false *2
*1 Oil Pressure Gauge
*2 Adapter


Install an oil pressure gauge with an adapter.


c.

Warm up the engine.


d.

Measure the engine oil pressure.

Standard Oil Pressure:
Condition Specified Condition
Idling 29 kPa (0.3 kgf/cm2, 4.2 psi) or higher
3000 rpm 245 kPa (2.5 kgf/cm2, 36 psi) or higher


If the pressure is not as specified, check the oil pump.


e.

Remove the oil pressure gauge and adapter.


f.

Install the engine oil pressure switch (See page Engine / Hybrid System>1KD-FTV LUBRICATION>OIL PRESSURE SWITCH>INSTALLATION).