Home › Engine / Hybrid System › 1KD-FTV LUBRICATION › OIL PUMP(w/ Glow Plug Controller) › from 2012.04
RM1840EF _51 Engine / Hybrid System _009600 1KD-FTV LUBRICATION _0052403 OIL PUMP(w/ Glow Plug Controller) G

1KD-FTV LUBRICATION  OIL PUMP(w/ Glow Plug Controller)  INSPECTION  


PROCEDURE

Hide 1.INSPECT OIL PUMP RELIEF VALVE

a.
P012091

Coat the relief valve with engine oil and drop it into the relief valve hole.


b.

Check that the relief valve falls in smoothly by its own weight.

If it does not, replace the relief valve. If necessary, replace the timing gear case assembly.


Hide 2.INSPECT OIL PUMP

a.
A303244
1.823,1.781 1.708,1.781 1.708,1.781 1.625,1.354 true 1.875,1.698 2.094,1.885 0.219,0.188 10 true *1
*1 Alignment Mark


Install the driven rotor to the timing gear case with the mark facing the cylinder block side.


b.
A051289

Check the tip clearance.

i.

Using a feeler gauge, measure the clearance between the drive and driven rotor tips.

Standard tip clearance:

0.060 to 0.160 mm (0.00236 to 0.00630 in.)


Maximum tip clearance:

0.21 mm (0.00827 in.)


If the tip clearance is more than the maximum, replace the timing gear case assembly.



c.
A051290

Check the body clearance.

i.

Using a feeler gauge, measure the clearance between the oil pump body and driven rotor.

Standard body clearance:

0.100 to 0.170 mm (0.00394 to 0.00669 in.)


Maximum body clearance:

0.20 mm (0.00787 in.)


If the body clearance is more than the maximum, replace the timing gear case assembly.



d.
A051291

Check the side clearance.

i.

Using a feeler gauge and precision straightedge, measure the clearance between the rotor and precision straightedge.

Standard side clearance:

0.030 to 0.090 mm (0.00118 to 0.00354 in.)


Maximum side clearance:

0.15 mm (0.00591 in.)


If the side clearance is more than the maximum, replace the timing gear case assembly.