1.INSPECT OIL PUMP RELIEF VALVE
Coat the relief valve with engine oil and drop it into the relief valve hole.
Check that the relief valve falls in smoothly by its own weight.
If it does not, replace the relief valve. If necessary, replace the timing chain cover.
2.INSPECT OIL PUMP ROTOR SET
| *1 | Mark |
Install the rotors to the oil pump body with the rotors' marks facing outward. Check that the rotors revolve smoothly.
Check the tip clearance.
Using a feeler gauge, measure the clearance between the drive and driven rotor tips, as shown in the illustration.
0.040 to 0.160 mm (0.00157 to 0.00630 in.)
0.260 mm (0.0102 in.)
If the tip clearance is more than the maximum, replace the timing chain cover.
Check the side clearance.
Using a feeler gauge and precision straightedge, measure the clearance between the rotors and precision straightedge, as shown in the illustration.
0.025 to 0.075 mm (0.000984 to 0.00295 in.)
0.130 mm (0.00512 in.)
If the side clearance is more than the maximum, replace the timing chain cover.
Check the body clearance.
Using a feeler gauge, measure the clearance between the oil pump body and driven rotor, as shown in the illustration.
0.025 to 0.325 mm (0.000984 to 0.0128 in.)
0.425 mm (0.0167 in.)
If the body clearance is more than the maximum, replace the timing chain cover.