Home › Engine / Hybrid System › 1GR-FE LUBRICATION › OIL PUMP › from 2012.04
RM1840EF _51 Engine / Hybrid System _009602 1GR-FE LUBRICATION _0052411 OIL PUMP G

1GR-FE LUBRICATION  OIL PUMP  INSPECTION  


PROCEDURE

Hide 1.INSPECT OIL PUMP RELIEF VALVE

a.
A072933

Coat the valve with engine oil, and then check that it falls smoothly into the valve hole by its own weight.

If the valve does not fall smoothly, replace the oil pump cover.


Hide 2.INSPECT OIL PUMP ROTOR SET

a.
A134834
1.625,0.698 0.948,0.698 true 1.635,0.146 1.198,0.146 1.198,0.146 1.198,0.688 true 0.76,0.615 0.958,0.792 0.198,0.177 10 true *1
*1 Alignment Mark


Place the drive and driven rotors into the timing chain cover with the Alignment marks facing upward.


b.
A072936

Check the rotor tip clearance.

i.

Using a feeler gauge, measure the clearance between the drive and driven rotor tips.

Standard tip clearance:

0.06 to 0.16 mm (0.00236 to 0.00630 in.)


Maximum tip clearance:

0.16 mm (0.00630 in.)


If the clearance is more than the maximum, replace the rotors as a set.



c.
A072937

Check the rotor side clearance.

i.

Using a feeler gauge and precision straightedge, measure the clearance between the rotors and precision straightedge.

Standard side clearance:

0.03 to 0.09 mm (0.00118 to 0.00354 in.)


Maximum side clearance:

0.09 mm (0.00354 in.)


If the clearance is more than the maximum, replace the rotors as a set. If necessary, replace the timing chain cover sub-assembly.



d.

Check the rotor body clearance.

i.
A072935

Using a feeler gauge, measure the clearance between the driven rotor and body.

Standard body clearance:

0.250 to 0.325 mm (0.00984 to 0.0128 in.)


Maximum body clearance:

0.325 mm (0.0128 in.)


If the clearance is more than the maximum, replace the rotors as a set. If necessary, replace the timing chain cover sub-assembly.