Home › Engine / Hybrid System › 1KD-FTV STARTING › STARTER(for DENSO Made) › 2011.10–2012.01
RM1840EF _51 Engine / Hybrid System _009603 1KD-FTV STARTING _0052413 STARTER(for DENSO Made) A

1KD-FTV STARTING  STARTER(for DENSO Made)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.REMOVE FRONT FENDER SEAL

a.

Remove the 5 clips and seal.


Hide 4.DISCONNECT CLUTCH RELEASE CYLINDER ASSEMBLY (for Manual Transmission)

Hide 5.REMOVE TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY (for Automatic Transmission)

Hide 6.REMOVE STARTER ASSEMBLY

A111843

a.

Disconnect the starter connector.


b.

Remove the nut and disconnect the starter wire.


c.
A122908

for Automatic Transmission:

Remove the 2 nuts, bolt, ground cable and starter.


d.
A301360

for Manual Transmission:

Remove the nut, bolt, ground cable and starter.