Home › Engine / Hybrid System › 1KD-FTV STARTING › STARTER(for DENSO Made)
RM1840EF _51 Engine / Hybrid System _009603 1KD-FTV STARTING _0052413 STARTER(for DENSO Made) A

1KD-FTV STARTING  STARTER(for DENSO Made)  DISASSEMBLY  


PROCEDURE

Hide 1.REMOVE STARTER YOKE ASSEMBLY

a.
P013020

Remove the nut and disconnect the lead wire from terminal C.


b.
A074859

Remove the 2 bolts and 2 O-rings.


c.

Pull out the starter yoke together with the starter armature.


d.

Remove the O-ring from the starter yoke.


Hide 2.REMOVE MAGNET STARTER SWITCH ASSEMBLY

a.
A102596

Remove the 2 bolts and magnet starter switch.


b.
A222616
1.74,0.458 1.823,0.229 1.823,0.229 1.906,0.229 false 2.052,0.75 2.198,0.24 2.198,0.24 2.292,0.24 false 2.479,0.865 2.583,0.427 2.583,0.427 2.667,0.427 false 2.833,0.906 2.938,0.406 2.938,0.406 3.031,0.406 false 2.781,1.531 2.875,1.281 2.875,1.281 2.979,1.281 false 1.969,1.667 1.729,1.802 1.729,1.802 1.635,1.802 false 0.656,1.167 0.438,0.719 0.438,0.719 0.344,0.719 false 1.906,0.104 2.188,0.26 0.281,0.156 10 *2 2.313,0.115 2.583,0.292 0.271,0.177 10 *3 2.698,0.302 2.948,0.469 0.25,0.167 10 *5 3.052,0.302 3.292,0.479 0.24,0.177 10 *4 2.99,1.167 3.229,1.344 0.24,0.177 10 *1 1.438,1.698 1.688,1.865 0.25,0.167 10 *6 0.156,0.625 0.427,0.792 0.271,0.167 10 *7
*1 Return Spring
*2 Pinion Gear
*3 Idler Gear
*4 Clutch Roller
*5 Retainer
*6 Starter Clutch
*7 Starter Housing


Remove the return spring, pinion gear, idler gear, clutch roller, retainer and starter clutch from the starter housing.


c.
A115020
2.688,0.417 2.573,0.417 2.573,0.417 2.146,0.74 false 2.76,0.323 3.135,0.563 0.375,0.24 10 *1
*1 Magnet Hand


Using a magnet hand, remove the steel ball from the starter clutch hole.


Hide 3.REMOVE STARTER BRUSH HOLDER ASSEMBLY

N000562

a.

Disconnect the 4 starter yoke brushes from the starter brush holder.

i.

Using a screwdriver, pull back the spring.


ii.

Disconnect the brush from the starter brush holder.



b.

Remove the starter brush holder from the starter yoke.


Hide 4.REMOVE STARTER ARMATURE ASSEMBLY

a.
A222477

Using a plastic-faced hammer, tap the starter yoke to remove the starter armature from the starter yoke.