Home › Engine / Hybrid System › 1KD-FTV STARTING › GLOW PLUG(w/o Glow Plug Controller)
RM1840EF _51 Engine / Hybrid System _009603 1KD-FTV STARTING _0052416 GLOW PLUG(w/o Glow Plug Controller) G

1KD-FTV STARTING  GLOW PLUG(w/o Glow Plug Controller)  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.CHECK GLOW PLUG

A301345
2.146,1.698 1.698,0.667 1.698,0.667 1.458,0.667 true 1.292,0.594 1.604,0.792 0.313,0.198 10 false *1
*1 Screw Grommet


a.

Remove the screw grommet.


b.

Measure the resistance according to the value(s) in the below.

Standard Resistance:
Tester Connection Condition Specified Condition
Glow plug terminal - Body ground 20°C (68°F) Approx. 0.95 Ω


If the result is not as specified, replace the glow plug.


NOTICE:
·

Be careful not to damage the glow plug pipes, as this may cause an open circuit or shorten the life of the glow plugs.

·

Do not allow oil or gasoline to contact the glow plug when cleaning it.

·

Clean any oil on the terminal and bakelite washer with a dry cloth.

·

Do not apply more than 11 V to the glow plug, as this may cause an open circuit.