Home › Engine / Hybrid System › 1KD-FTV STARTING › RELAY
RM1840EF _51 Engine / Hybrid System _009603 1KD-FTV STARTING _0052418 RELAY G

1KD-FTV STARTING  RELAY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT STARTER RELAY (ST)

a.
B060778
2.031,0.729 1.677,0.333 true 2.625,0.729 2.99,0.365 true 2.354,1.104 3,0.948 true 2.354,1.604 3,1.479 true 1.552,0.25 1.698,0.417 0.146,0.167 10 false 1 3.021,0.271 3.167,0.427 0.146,0.156 10 false 2 3.031,0.865 3.219,1.021 0.188,0.156 10 false 5 3.042,1.385 3.167,1.542 0.125,0.156 10 false 3 1.167,0.76 1.333,0.938 0.167,0.177 10 false 5 1.167,1.292 1.313,1.458 0.146,0.167 10 false 2 0.25,0.74 0.396,0.906 0.146,0.167 10 false 3 0.24,1.271 0.354,1.438 0.115,0.167 10 false 1

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 - 5 Battery voltage not applied to terminals 1 and 2 10 kΩ or higher
Battery voltage applied to terminals 1 and 2 Below 1 Ω


If the result is not as specified, replace the starter relay.


Hide 2.INSPECT GLOW RELAY

a.
A301376
2.333,0.792 2.635,0.51 false 2.052,1.75 2.344,1.438 false 1.656,1.115 2.01,1.115 false 2.656,1.115 3.01,1.115 false 0.281,1.313 0.438,1.51 0.156,0.198 10 1 1.271,1.323 1.427,1.521 0.156,0.198 10 2 0.302,0.771 0.458,0.969 0.156,0.198 10 3 1.271,0.781 1.427,0.979 0.156,0.198 10 5 2.677,0.427 2.833,0.625 0.156,0.198 10 1 1.938,1.708 2.094,1.906 0.156,0.198 10 2 1.51,1.031 1.667,1.229 0.156,0.198 10 3 3.063,1.031 3.219,1.229 0.156,0.198 10 5

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 - 5 Battery voltage not applied to terminals 1 and 2 10 kΩ or higher
Battery voltage applied to terminals 1 and 2 Below 1 Ω


If the result is not as specified, replace the glow relay.