Home › Engine / Hybrid System › 1KD-FTV STARTING › STARTER(for BOSCH Made) › 2011.10–2012.01
RM1840EF _51 Engine / Hybrid System _009603 1KD-FTV STARTING _0052419 STARTER(for BOSCH Made) A

1KD-FTV STARTING  STARTER(for BOSCH Made)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.REMOVE FRONT FENDER SEAL

a.

Remove the 5 clips and seal.


Hide 4.DISCONNECT CLUTCH RELEASE CYLINDER ASSEMBLY

Hide 5.REMOVE STARTER ASSEMBLY

a.
A201713

Disconnect the starter connector.


b.

Remove the nut and disconnect the starter wire.


c.
A201714
1.229,1.385 1.271,1.385 1.271,1.385 1.385,1.219 false 1.021,1.302 1.323,1.448 0.302,0.146 10 *1
*1 Ground Cable


Remove the 2 bolts and disconnect the ground cable.


d.

Remove the starter.