Home › Engine / Hybrid System › 1KD-FTV STARTING › GLOW PLUG CONTROLLER(w/ Glow Plug Controller) › 2012.04–2012.10
RM1840EF _51 Engine / Hybrid System _009603 1KD-FTV STARTING _0052421 GLOW PLUG CONTROLLER(w/ Glow Plug Controller) A

1KD-FTV STARTING  GLOW PLUG CONTROLLER(w/ Glow Plug Controller)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.REMOVE BATTERY BRACKET

a.

Remove the bolt, nut and battery bracket.


Hide 4.REMOVE BATTERY AND BATTERY TRAY

Hide 5.REMOVE GLOW PLUG CONTROLLER

A280054

a.

Disconnect the 4 connectors.


b.

Remove the bolt, nut and glow plug controller from the vehicle.


Hide 6.REMOVE NO. 1 GLOW PLUG CONTROLLER BRACKET

a.

Remove the 2 screws and No. 1 glow plug controller bracket from the glow plug controller.


Hide 7.REMOVE NO. 2 GLOW PLUG CONTROLLER BRACKET

a.

Remove the 2 screws and No. 2 glow plug controller bracket from the glow plug controller.