Home › Engine / Hybrid System › 1KD-FTV STARTING › GLOW PLUG(w/ Glow Plug Controller) › from 2012.10
RM1840EF _51 Engine / Hybrid System _009603 1KD-FTV STARTING _0052422 GLOW PLUG(w/ Glow Plug Controller) A

1KD-FTV STARTING  GLOW PLUG(w/ Glow Plug Controller)  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the injectors (including shuffling the injectors between the cylinders), common rail or cylinder head, it is necessary to replace the injection pipes with new ones.

·

When replacing the fuel supply pump, common rail, cylinder block, cylinder head, cylinder head gasket or timing gear case, it is necessary to replace the fuel inlet pipe with a new one.

·

After removing the injection pipes, clean them with a brush and compressed air.

·

Remove the glow plugs while they are still warm after completely warming up the engine.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 4.REMOVE GLOW CONNECTOR BRACKET

A253492

a.

Disconnect the No. 1 glow plug connector and detach the clamp.


b.
A254198

Remove the bolt and glow connector bracket.


Hide 5.REMOVE NO. 2 MANIFOLD STAY

a.
A245458

Remove the bolt and No. 2 manifold stay.


Hide 6.REMOVE NO. 1 GLOW PLUG CONNECTOR

a.
A247184

Remove the 4 screw grommets.


b.
A247185

Remove the 4 nuts and No. 1 glow plug connector.


Hide 7.REMOVE NO. 1 INTAKE MANIFOLD INSULATOR

A256544

Hide 8.REMOVE GLOW PLUG

A282167

a.

Using a 12 mm deep socket wrench, remove the 4 glow plugs.