Home › Engine / Hybrid System › 2KD-FTV STARTING › STARTER(for DENSO Made) › 2011.10–2012.01
RM1840EF _51 Engine / Hybrid System _009604 2KD-FTV STARTING _0052423 STARTER(for DENSO Made) A

2KD-FTV STARTING  STARTER(for DENSO Made)  INSTALLATION  


PROCEDURE

Hide 1.INSTALL STARTER ASSEMBLY

a.

Connect the ground cable and install the starter with the nut and bolt.

Torque:
68 N*m (693 kgf*cm, 50 ft.*lbf)


b.

Install the starter wire to terminal 30 with the nut.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)


c.

Connect the starter connector.


Hide 2.CONNECT CLUTCH RELEASE CYLINDER ASSEMBLY

Hide 4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).