Home › Engine / Hybrid System › 2KD-FTV STARTING › STARTER(for DENSO Made) › from 2012.10
RM1840EF _51 Engine / Hybrid System _009604 2KD-FTV STARTING _0052423 STARTER(for DENSO Made) A

2KD-FTV STARTING  STARTER(for DENSO Made)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 4.DISCONNECT CLUTCH RELEASE CYLINDER ASSEMBLY

Hide 5.REMOVE STARTER ASSEMBLY

a.
A195903

Disconnect the starter connector.


b.

Remove the nut and disconnect the starter wire.


c.
A195904

Remove the nut, bolt, and disconnect the ground cable.


d.

Remove the starter.